當前位置: 首頁>>編程示例 >>用法及示例精選 >>正文


Arduino Ethernet - EthernetUDP.parsePacket()用法及代碼示例

說明

檢查是否存在 UDP 數據包,並報告大小。 parsePacket() 必須在使用 UDP 讀取緩衝區之前調用。read()。

用法

EthernetUDP.parsePacket();

參數

None

返回

  • int:接收到的UDP數據包的大小

示例


#include <SPI.h>         // needed for Arduino versions later than 0018
#include <Ethernet.h>
#include <EthernetUdp.h>         // UDP library from: bjoern@cs.stanford.edu 12/30/2008


// Enter a MAC address and IP address for your controller below.
// The IP address will be dependent on your local network:
byte mac[] = {  
  0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED };
IPAddress ip(192, 168, 1, 177);

unsigned int localPort = 8888;      // local port to listen on

// An EthernetUDP instance to let us send and receive packets over UDP
EthernetUDP Udp;

void setup() {
  // start the Ethernet and UDP:
  Ethernet.begin(mac,ip);
  Udp.begin(localPort);

  Serial.begin(9600);
}

void loop() {
  // if there's data available, read a packet
  int packetSize = Udp.parsePacket();
  if(packetSize)
  {
    Serial.print("Received packet of size ");
    Serial.println(packetSize);
  }
  delay(10);
}

相關用法


注:本文由純淨天空篩選整理自arduino.cc大神的英文原創作品 Ethernet - EthernetUDP.parsePacket()。非經特殊聲明,原始代碼版權歸原作者所有,本譯文未經允許或授權,請勿轉載或複製。