說明
設置以太網控製器的超時。初始值為 200 毫秒。 200 ms 超時乘以默認的 8 次嘗試等於通信失敗期間 1600 ms 的阻塞延遲。您可能更喜歡設置更短的超時時間,以使您的程序在通信出現問題時更具響應性。您將需要進行一些實驗以確定適合您的特定應用的值。
用法
Ethernet.setRetransmissionTimeout(milliseconds)
參數
- 毫秒:超時持續時間(uint16_t)
返回
無
示例
#include <SPI.h>
#include <Ethernet.h>
byte mac[] = {0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED};
IPAddress ip(10, 0, 0, 177);
void setup() {
Ethernet.begin(mac, ip);
Ethernet.setRetransmissionTimeout(50); // set the Ethernet controller's timeout to 50 ms
}
void loop () {}
相關用法
- Arduino Ethernet - Ethernet.setRetransmissionCount()用法及代碼示例
- Arduino Ethernet - Ethernet.setDnsServerIP()用法及代碼示例
- Arduino Ethernet - Ethernet.setMACAddress()用法及代碼示例
- Arduino Ethernet - Ethernet.setSubnetMask()用法及代碼示例
- Arduino Ethernet - Ethernet.setLocalIP()用法及代碼示例
- Arduino Ethernet - Ethernet.setGatewayIP()用法及代碼示例
- Arduino Ethernet - Ethernet.subnetMask()用法及代碼示例
- Arduino Ethernet - Ethernet.MACAddress()用法及代碼示例
- Arduino Ethernet - Ethernet.hardwareStatus()用法及代碼示例
- Arduino Ethernet - Ethernet.localIP()用法及代碼示例
- Arduino Ethernet - Ethernet.init()用法及代碼示例
- Arduino Ethernet - Ethernet.dnsServerIP()用法及代碼示例
- Arduino Ethernet - Ethernet.gatewayIP()用法及代碼示例
- Arduino Ethernet - Ethernet.linkStatus()用法及代碼示例
- Arduino Ethernet - Ethernet.begin()用法及代碼示例
- Arduino Ethernet - EthernetUDP.parsePacket()用法及代碼示例
- Arduino Ethernet - EthernetUDP.beginPacket()用法及代碼示例
- Arduino Ethernet - EthernetUDP.available()用法及代碼示例
- Arduino Ethernet - EthernetUDP.read()用法及代碼示例
- Arduino Ethernet - EthernetUDP.endPacket()用法及代碼示例
- Arduino Ethernet - EthernetUDP.begin()用法及代碼示例
- Arduino Ethernet - EthernetServer()用法及代碼示例
- Arduino Ethernet - EthernetClient()用法及代碼示例
- Arduino Ethernet - EthernetUDP.write()用法及代碼示例
- Arduino Ethernet - server.begin()用法及代碼示例
注:本文由純淨天空篩選整理自arduino.cc大神的英文原創作品 Ethernet - Ethernet.setRetransmissionTimeout()。非經特殊聲明,原始代碼版權歸原作者所有,本譯文未經允許或授權,請勿轉載或複製。